Hi all,
I got my Jackson DK2M the other day and I set it up and I it holds tune very well, but then as I was bending a string doing a lead I noticed that I wasn't able to make the note...
Upon looking it over I saw as I bend the one string the Trem would rise just enough to not make the note.

I waited along time to get this guitar and I can't afford to put more money in a guitar that should be 100% already.

I had two extra springs and I added them one at a time and it still didn't help. I even tried to float the Trem under level to see if that would compensate.. I tried to tighten the claw screws more and that didn't help either...

Any suggestion?

Thanks

_________________
Jackson DK2M
Epi LP Custom
Bugera 333XL 212
Line 6 M9 Stompbox

Is this your first floyd guitar? I have 5 guitars with floyd and all do that, but its no problem to make the bend correct.

Hey thanks for the reply.

I found all is well with the Floyd, and it has been to long since I owned one.
Turns out I have asked and also went and tried a few others and yes they all do rise on the bends.

All is well! Mine is set and forget..

Topic Closed.

_________________
Jackson DK2M
Epi LP Custom
Bugera 333XL 212
Line 6 M9 Stompbox